I'm not sure what this error means. Looking at the script the reference line does not really mean anything to me.

Everything has been working fine. Yesterday I changed the coordinates to point the scope at when taking screen flats.

I change DoFlatAlt from 1 to -2
I changed DoFlatAZ from 1 to 180
Here is a copy/past from the config file.

; These coordinates are used to point the telescope at the flat panel/screen
; Comment these out if you don't want the scope moved here.
;
DoFlatAlt -2 ; Altitude of flat panel/screen
DoFlatAz 180 ; Azimuth of flat panel/screen
;

I slewed the scope there to make sure that TheSkyX would go there (near the park position) and it slewed there without any problems. I did not check to make sure ACP would point the scope there....actually not real sure how to do that...

This morning I got the following error when starting autoflat script
24-Mar-2016 12:25:58.4: ++ Morning Screen Flats ++
24-Mar-2016 12:25:58.4: Start ACP AutoFlat script for panel/screen flats
24-Mar-2016 13:26:45.0: Dispatcher stopped at 24-Mar-2016 13:26:45 UTC
24-Mar-2016 13:26:45.0: **DISPATCHER INTERRUPT LEVEL 1 RECEIVED**
24-Mar-2016 13:27:28.2: ** ACP script "AutoFlat" failed:
24-Mar-2016 13:27:28.2: **Script Error**
Source: ACP
Message: The script was aborted.
Location: line 2216 column 9.

24-Mar-2016 13:37:13.1: **EXCEPTION IN SCHEDULER:
24-Mar-2016 13:37:13.1: The callee (server [not server application]) is not available and disappeared; all connections are invalid. The call may have executed. (Exception from HRESULT: 0x80010007 (RPC_E_SERVER_DIED))
24-Mar-2016 13:37:13.2: Traceback:
at ACP.UtilClass.get_Scheduler()
at DC3.Scheduler.ACPSequencer.set_DispatcherStatus(St atusValue value)
at DC3.Scheduler.Engine.set_Status(StatusValue value)
at DC3.Scheduler.Engine.Run()
24-Mar-2016 13:37:13.2: DOME/ROOF FAILURE: In addition, attempting to close your dome/roof this error occurred:
24-Mar-2016 13:37:13.2: The callee (server [not server application]) is not available and disappeared; all connections are invalid. The call may have executed. (Exception from HRESULT: 0x80010007 (RPC_E_SERVER_DIED))


I am running scheduler, but I think this is on the ACP side of the fence.

I thought the FlipFlat might have a connection problem, so logged in remote and started that program....connected fine, operated fine.

Any ideas?

Thanks,
W