Results 1 to 2 of 2

Hybrid View

  1. #1
    Join Date
    Jan 2016
    Posts
    1

    Default Interpolation Question

    Hello,

    I have recently begun making use of the NEO (Ra/Dec) ephemerides input mode offered by ACP (http://support.dc3.com/plandoc/neofmt.html). This has generally worked well, but I have run into an strange issue:

    Typically I generate plans in which the targets are specified by two Ra/Dec coordinates an hour apart. The software appears to correctly interpolate (or extrapolate) from these if the interpolation time is before the midpoint of the two ephemeris times. After the midpoint, it generates a significantly different result which appears to be the second ephemeris point multiplied by 2, which leads to a failed target acquisition. So if a series of targets are specified with ephemerides spanning 1AM-2AM, the interpolation will be performed correctly until the local time reaches 1:30AM, at which point the interpolation breaks down. Is this a known issue, and is there a workaround I could try (perhaps using 3 points instead of 2)?

    I also had a couple of general questions about this input mode:
    The documentation above seems to suggest that only ephemeris points on the hour should be used. Is this true, or is it supported to add minutes (presumably by adding a two digit integer between the hour and the right ascension)?
    Out of curiosity, how is this interpolation being performed for more than 2 points? I seem to remember reading somewhere that it is using Lagrange Interpolation - is this the case?

    Thanks,
    Alex

  2. #2
    Join Date
    Oct 2005
    Location
    Mesa, AZ
    Posts
    26,048

    Default

    Alex -- This is the pre-sales section and I am guessing that you are not a pre-sale customer. Your question could result in significant research and time, so I just want to determine if you are actually a customer and if so figure out why you aren't seeing the customer tech support sections here.
    -- Bob

 

 

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •