I'm about to launch this setup. I have chosen Direct guide under the control via tab in the guider area of MaxmDL. I have the correct driver installed for the mount control, that is, ASCOM controlled Sky X. A few clarifying questions.
First, I assume I follow the instructions for calibration, that is, first the AO then the drive for the mount?
Once I"ve done the mount calibration, will the angle that ACP needs still be in the same place within MaximDL???
Do I need to, someplace, inside ACP do anything else than usual? In other words, now, I just copy that angle over into ACP and I"m done. Since I'm now using the AO, does ACP need any other metrics updated/changed????
Thanks in advance
Peter