I'm having a repeatable crash in ACP when I hit the STOP SLEW button in ACP.
1) If I start a slew, and then hit the STOP SLEW button, I get the following in the Console output:
[**HARDWARE OR DRIVER ERROR**] [Source: TheSkyXAdaptor.RASCOMTele.1]
[Process aborted. Error = 212.]
[This is not an ACP problem]
At this point the telescope is no longer connected to ACP....but I can re-connect the telescope and the scope finds home.
Sometimes, however, I get an ACP dialog box saying
Object variable or With block variable not set.
Dismissing this error just causes the same dialog to be shown again. I have to use task mgr to kill ACP.
- Dick