I noticed that there is a power off script for Data Loggers Web Power Switch units and wondered if anyone has written a similar script for the APC AP7900 unit? I know it is possible as the scripting information is on APC's website but I might as well be reading Latin, which I don't know, and I have zero scripting experience since the long ago days of Basic and that's a mere memory. I have a DL unit that has been out of service for a few years due to what I believe is a lost Ethernet board. Where it was used had some electrical problems that were later resolved and the unit was replaced with the above mentioned APC unit. So that one is remote and I have have one here for my local use. Any ideas would be great as I'm now getting Scheduler set up and it would be great to be able to power on and off as needed via Scheduler if possible as well as ACP stand alone.

Thanks,