Hi,

I have Acp 7.0 with maxim dl 5.18 and a sitech controller.
Guiding is via an off axis guider.
I calibrate guiding perfectly and test it in maxim and it guides very well.
When i do a target in acp it starts guiding but the guiding spirals out of control and the stars in a 120s sub look like a comma, it's literally a spiral.
Maxim no longer guides properly but if i calibrate again then maxim returns to normal.
Guiding is set to ascom direct and i've tried both the acp hub and the sitechii driver as the connection.

Any help would be appreciated as i'm a bit stuck, not sure if its a sitech, maxim or acp setting.


Thanks