Hi everyone!

A few nights ago I had an issue with parking the mount. I think it has to do with something other than ACP but thought I would ask anyway.

I am using ACP to control an AP mount using the version 2 driver. It is a remote setup. I parked the mount via the web interface then shut down the power. The following day the site operator told me that the scope was pointing near zenith. The mount did not know where it was when it was powered up again. Am I likely to have missed something in ACP? I had parked it prior to this but only via the ACP console on the observatory computer.

What I really what to ask is what is the best method to set a park position and reliably park it? In the past the park position has been set via The Sky but that option is now greyed out. The Sky is connected to the mount via ACP.