I am going through the frustration of learning ACP Planner.

I watched all the videos.

I set it up, correctly I think.

I put in the imaging plan, a simple RGB.

It seemed to buy it, saying all the right things, including that it would start imaging at 10:30 local time (which is in West Australia).

But all it did was shut down at 10:30, saying that the target wasn't high enough.

I need to be able to go to bed, telling it to start sometime later, and have it start, not turn off. If the target's not high enough, I need for it to wait for the target to be high enough.

How to do this?

Arggghhh.....

Mark