Results 1 to 10 of 15

Threaded View

  1. #2
    Join Date
    Nov 2008
    Location
    Albuquerque(me) / Rincona(scope), NM
    Posts
    636

    Default

    I suspect that you haven't yet set up Focus Offsets in ACP.

    Make sure you have filter names still set up correctly in MaxIm 5. Then you can run the script FocusOffsets.vbs--it runs for about 20 minutes to an hour depending on FocusMax settings and number of filters. (I've also found it's best to run the script when after the scope has cooled well and is roughly temperature equilibrated.)

    Let us know the outcome...
    Last edited by Eric Dose; Nov 15, 2009 at 13:04. Reason: corrected estim. run time for FocusOffsets script
    New Mexico Mira Project, Albuquerque NM

 

 

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Maxim 6.0.5 raises Reference Filter Invalid Error
    By Lawrence Van Vleet in forum Hardware/Software/Driver Topics Not Directly Related to Our Software
    Replies: 9
    Last Post: Aug 29, 2014, 22:14
  2. Getting Filter Information from MaxIm
    By Peter Nelson in forum ACP Planner
    Replies: 7
    Last Post: Feb 22, 2013, 02:18
  3. NTM Mount slews when tracking rates are changed [was: Moving target]
    By TRAPPIST in forum Hardware/Software/Driver Topics Not Directly Related to Our Software
    Replies: 21
    Last Post: Jan 7, 2013, 16:18
  4. Fixing LX200 RA Runaway - compliment to the Master
    By Dick Berg in forum Hardware/Software/Driver Topics Not Directly Related to Our Software
    Replies: 4
    Last Post: Nov 12, 2010, 15:24

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •