Folks - I'm considering buying an automated system that monitors weather and feeds back data to ACP.

I would prefer an off-the-shelf configuration rather than a DIY job. I can't solder and my software writing skills are as good as my soldering

I would like the system to be able to monitor wind, moisture (rain, snow etc), temperature/humidity and cloud cover. It will then interact with ACP and then take appropriate action (i.e. close a dome/roof or even prevent it opening etc).

The two systems I've seen on the net and seem to be used to a greater/lesser extent are the Boltwood II sensor and Foster Systems stuff (www.fostersystems.com/amc101m.html)

Any thoughts, experiences, comments, feedback would be appreciated.

Cheers
Dave