I've looked through the threads (and manual) and haven't found an answer to the issue below.
We're using DDW to control our Dome and using ACP. Due to problems with DDW dropouts, we've gone to a configuration where the ACP is not controlling the dome. This seems to work well except for the meridian flip. When a flip happens, the dome slews lots slower than the telescope and so ACP is ready to start imaging again before the dome gets all the way slewed around.
ACP does command a rotator flip after doing the meridian flip and so it seems to me that there is a "post flip" flag somewhere that I could use to add in a delay in our plans. I haven't found the method yet though. Could someone help?