Hi George,

(By the way point 6,7and 8 seem like they should be 4,5and 6)...
Oops, guess I can't count!

Every once in awhile the pyxis will slip just a bit giving a misalignment value different from the usual 10.3 deg. If im aware of it I can just re-home the pyxis and everything is fine. Is there anyway to have a plan re-home the pyxis?
I don't think so. I'm sure it wouldn't be hard to implement, though. In the meantime, there might be a way to tighten up the Pyxis clutch. Perhaps that's worth pursuing with Optec? I guess the good thing is ACP does deal with it automatically with any plate-solves.

Regards,

Jim