Hello Bob and Wizards,

I finally got around to setting up autofocus with FocusMax v 5.1.0.16 and invoked Autofocus.vbs from ACP. The autofocus finished successfully, but the focuser was then disconnected in FocusMax and the telescope stopped tracking in Planewave's PWI4. Perhaps this is normal, but before I trust autofocus to run during a scheduled observation, I want to confirm this behavior won't prevent a plan from executing.

As usual, I suspect operator error. Any suggestions where to look to confirm this behavior is normal, or if not, where to look to make a correction?

Thank you,

George