This one has me stumped. This definitely seems like an AceSmartDome problem but I can't quite figure out what the deal is. Posting here in the hopes that someone can lend some guidance.

After getting upgraded hardware for our dome controller, we have been upgrading the control software. We are running on Win10 and it is up to date. We upgraded to ASCOM 6.6, ACP 9, the latest Astro-Physics telescope mount driver, and AceSmartDome.
When connecting to the telescope WITH the dome enabled gives this error:


So, we shut down ACP and went to the new ASCOM Device Hub to test the dome. The chooser works fine and I get this message:

But then when actually connecting to the dome, I get this:


I am not sure what to make of it. Ideas?