Results 1 to 3 of 3

Threaded View

  1. #1

    Default 10 Micron error: Sync matching failed

    On sept 17, during an imagaing run, the first Autofocus was successful.
    The next scheduled Autofocus failed. So did all later Autofocuses.


    On sept 17 I was using FocusMax 3.84.
    Meanwhile installed FM V4, but Autofocus still fails with the same error message.


    If my interpretation is correct the mount may be at fault although imaging, slews and guiding are Ok.


    If the mount is causing the problem, would it be possible to nail down the problem a bit further to facilitate the repair?


    The file LastAFTime shows sept 17, 19:38:39 and seems to confirm my observation.


    Appreciate your help.
    Attached Files Attached Files

 

 

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 10 Micron Scope does not raise error on failure of Connected=True
    By Peter Hannah in forum Hardware/Software/Driver Topics Not Directly Related to Our Software
    Replies: 3
    Last Post: Sep 23, 2020, 13:34
  2. System.Dynamic error from TheSky when trying to Sync
    By A Michael Smith in forum Hardware/Software/Driver Topics Not Directly Related to Our Software
    Replies: 5
    Last Post: Feb 22, 2017, 23:21
  3. CCDStack flat matching
    By Geoff Stone in forum Hardware/Software/Driver Topics Not Directly Related to Our Software
    Replies: 18
    Last Post: Aug 7, 2016, 12:39

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •