Results 1 to 7 of 7
  1. #1

    Default Pin Point license

    Greetings Dc-3 I purchased your pinpoint on May 4 2009 is there anyway to download the pinpoint associated with that license . I have been away from observing for quite sometime, but now that I am retired I am going to see if I can get back into it. My original email associated with that license has changed also.
    Thanks
    John Kerste

  2. #2
    Join Date
    Oct 2005
    Location
    Mesa, AZ
    Posts
    33,627

    Default

    You can download PinPoint 5.1d via the following link:

    http://download.dc3.com/OlderPinPoin...5.1d-setup.msi

    I just sent your license to the warpdrive address. If you'll tell me your newer email, I can change it, re-issue the license and send it to the new email. I apologize for any delay in response, Stephanie is out of down for a death in the family.

    Be aware that the old 5.1 PinPoint might not work with newer software that hosts it, as some functions were not in the engine back then.
    -- Bob

  3. #3

    Default

    Hi Bob how should I send you my new email, here or is there a private window. Also I will try the old pinpoint, if it gives me problems how much would an upgrade to the latest cost.
    Thanks for your help
    John

  4. #4
    Join Date
    Oct 2005
    Location
    Mesa, AZ
    Posts
    33,627

    Default

    Since your license is 7 years out of date, you'll have to buy a full license. Our cutoff is 5 years. It's $149. If you're concerned about posting your email here, send it to support@dc3.com. Thanks!!
    -- Bob

  5. #5

    Default

    Hi Bob I sent my new email, for some reason it's not taking it so if you could send the key to my new address I will see if that works.

    Thanks
    John

  6. #6
    Join Date
    Oct 2005
    Location
    Mesa, AZ
    Posts
    33,627

    Default

    Ok, little problem here. Stephanie's flight to Oregon got cancelled. Extremely bad weather there. I am at the airport waiting for her and her checked luggage. It's been a rough go for the past few days with a death in the family. It may be tomorrow before I am able to get back to helping you. I apologize.
    -- Bob

  7. #7

    Default

    absolutely no problem Bob

 

 

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •